08/24/10 PN 96493 v.4.0Banks Power Pack®System Including Stinger® Stinger®Plus, Monster® Exhaust1994-1998 Ford Power Stroke 7.3L turbo diesel THIS M
Figure 810
Figure 9 11
18. Adjust the Techni-Cooler side-to-side position to provide an identical distance between the intercooler hose connections and the sides of the radi
25. Loosen the clamps and remove from between the plastic air filter housing duct and the aluminum elbow. Unbolt a
33. Tighten the lower clamp on each of the intake manifold hoses. Attach the tabs on the TwinRam and the compressor outlet elbow with a 5⁄16
end tanks clear the support. Trim additional material if required to provide 1⁄8-inch minimum clearance on each end tank.35. Reinstall the grille open
GAUGE PANEL1. If the gauges are being installed step may be skipped. If gauges and
DYNAFACT BOOST GAUGE8. Locate the rubber hose connecting the intake manifold on the passenger-side of the engine to the manifold pressure sensor mount
1. Be certain battery ground cables have been disconnected. Locate the engine control unit (ECU) in a recess in the firewall on the engine
Figure 17 19
Banks Monster® Exhaust SystemSingle (P/N 46296-46299)temperatures (EGTs) and increases
Observe operation of the boost and pyrometer gauges while driving under varying conditions. Turbocharger boost pressure fluctuates as a function of lo
NotificationThe Banks Ram-Air Filter comes pre-oiled and no oiling is necessary for initial installation. Use Banks Ram-Air Filter cleaning system (pa
Section 9GENERAL ASSEMBLY AND BILL OF MATERIALS22
23
Bill of Materials*Stinger systems 48401, 48403 and 48405 use tailpipe p/n 52129*Stinger-Plus systems 48451, 48453 and 48455 use tailpipe p/n 52129*Pow
Figure 6
This page intentionally left blank
Figure 7
Gale Banks Engineering CA 91702 (626) 969-4-17Product Information & Salesbankspowe
Banks Stinger SystemsContains:- Ram-Air Intake Filter- Big Hoss Module- TransCommandBanks Stinger-Plus Systems(P/N 48553-48554, 4855
1. For ease of installation of your Banks Stinger®®-Plus or Power Pack®yourself with the procedure by reading the entire
1. Replace the stock air filter element with the Banks Ram-Air filter.2.by removing the clamp at the catalytic converter o
Section 2TURBOCHARGER REMOVALFigure 26
For Stinger system, proceed to Section 31. Loosen the clamps holding the air intake hose to the turbocharger compressor inlet and the aluminum air int
1.and cooler line if removed. Be sure to connect the electrical ground between the cylinder head and dipstick m
For Stinger and Stinger Plus systems, proceed to Section 51. Cover the compressor inlet and discharge with clean rags so that no foreign material will
Commentaires sur ces manuels